PureFlow AirDog FP-150 - 6.0L Ford 2003-2007 - Manual (Page 19)

19
AirDog
®
FP-100 & FP-150 Ford PowerStroke 2003-2007 6.0L
Section 6 Electrical Harness
Connecting the AirDog
®
Relay Control Lead
6-2. Route the AirDog
®
'Relay activation lead', to the fuse panel on the dash to the left of
the steering column. Insert the mini fuse tap into a spare fuse holder on the panel that
is “hot” when the starter key is turned to the on position.
Figure 64 Figure 65
6-3. OR Route the AirDog
®
'Relay activation lead, 'the Red (+) wire with the mini fuse tap
attached, to the OE fuel pump. Remove the mini fuse tap and splice the relay lead to
the OE fuel pump lead
NOTE: The power supply leads can be connected to the battery or the alternator. Connecting
the power supply leads to the alternator instead of the battery will create a corrosion free
connection.
Black (-) Red (+)
6-4. Route the power supply leads to the alternator.
Connect the Black (-) lead to the alternator
Ground connection.
Connect the Red (+) lead to the alternator Hot
Lead going to the battery.
Figure 66
OR
6-5. Should you choose to connect the power
supply leads directly to the battery, connect
the RED (+) lead to the POSITIVE (+) post
of the driver's side battery. Connect the
BLACK (-) lead to the NEGATIVE (-) post
of the same battery.
Figure 67
6-6.
Route the wiring harness to the AirDog
®
and connect the 2 pin Deutsch connector
to the corresponding connector on
the AirDog
®
.
Figure 68