Fuel supply line from the airdog – PureFlow AirDog FP-150 - 6.0L Ford 2003-2007 User Manual
Page 11
11
AirDog
®
FP-100 & FP-150 Ford PowerStroke 2003-2007 6.0L
Section 5-A Fuel Lines
Fuel Supply Line from the AirDog
®
to the High Pressure Pump
5A-1 Remove the original factory fuel supply line at the electric OE lift pump, located on
the driver’s side inside frame rail by squeezing the tabs on the end of the connector
together. Push the quick connect fitting toward the OE lift pump while firmly
depressing the tabs. With the tabs depressed, pull the fitting assembly from the inlet
tube. Use care to hold the quick connect fitting squarely onto the inlet tube. It may be
difficult to disconnect the fitting if it becomes cocked during removal.
High Pressure Fuel Pump
With 3/8” Quick Connect Fitting
Figure 15
5A-2. Attach, by pushing, the female SAE J2044 quick connect end (Figure 16) of the
“Pressure Hose Assembly” onto the factory male quick connect that was disconnected
in 5A-1 (Figure 15). You will hear a “click” when properly connected.
Figure 16
5A-3. Insert the female quick connect end (see figure 17) of the “pressure hose
assembly” into the male quick connect fitting previously installed in the port
marked “ENGINE”. You will hear a “click” when it connects.
Figure 17
5A-4. Any excess fuel hose can be addressed by routing the hose in a fashion to take up the
extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.