PureFlow AirDog DF-200 - Dodge Cummins 2005-2013 - Manual (Page 14)

14
PureFlow AirDog
AirDog
®
II DF-200 Dodge 2005 - 2011
Section 5-C High Flow Suction Tube
INSTALLING THE AIRDOG
®
HIGH FLOW SUCTION TUBE
The AirDog
®
II DF-200 includes a ½” High Flow suction tube to accommodate the high
flows of this system. To install the ½ suction tube it is necessary to either drop the fuel tank
or to lift the truck bed.
NOTE: Should you choose to drop the fuel tank, support the tank as it is when it is installed
on the truck. If you let it rest flat on the floor, the tank may squash out and the suction tube
will be too short after the tank is re-installed in the truck. The suction tube, being cut too
short may suck air as the fuel drops below ¼ tank level.
NOTE: Should you choose to pull the pickup bed to access the tank. Be sure to disconnect
the tail light wires, fuel tank filler tube, and any other accessories or components that may be
secured to the frame and bed.
When Dropping the Tank, Always Remember Safety First!
Figure 21
Figure 22
Figure 23
If you choose to remove the bed, properly support the truck bed to prevent
serious injury or death!
Figure 24 Figure 25