PureFlow AirDog DF-200 - Dodge Cummins 2005-2013 User Manual

Page 13

PureFlow AirDog

AirDog

II DF-200 Dodge 2005 - 2011

Section 5 B Fuel Lines

Fuel Supply Line from the AirDog

II to the CP-3

For the 6.7L Engine, cont’d

5B-3 Insert the female quick connect end (see figure 20) of the

“Pressure Hose Assembly” into the male quick connect
fitting previously installed in the port marked “ENGINE”.
You will hear a “click” when it connects.

Figure 20

5B-4. Connect the other end of the “Pressure Hose Assembly” to the inlet fitting previously

installed in step 5B-2. It will also “click” when properly connected.

5B-5

Any excess fuel hose can be addressed by routing the house in a fashion to take up the

extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.

“ENGINE”. Properly torque the fitting.

NOTE: Having routed the fuel line directly to the CP3, it is suggested to cap or plug the inlet
and outlet ports of the bypassed filter canister. BE SURE TO RECONNECT THE
INJECTOR PUMP AND ENGINE RETURN LINES AS THEY WERE ORIGINALLY.

CAUTION: When installing the AirDog

II fuel lines, be sure to reconnect the ORIGINAL

ENGINE RETURN LINE to the fuel module as it was originally installed from the factory!