Rear panel overview, Power switch, Optional bncs – BNC 745 User Manual
Page 9: Ethernet port, Usb port (option)
Model 745 Digital Delay Generator.
November 2013
4- R
EAR
P
ANEL
O
VERVIEW
All optional output connectors/modules appear on that side of the device. The other features are
listed below.
Figure - 2.
Rear panel
Power Switch
The unit is turned on by depressing the Power button. The MOD745 can be operated from 100 to
240V at a line frequency of 50-60Hz.
Optional BNCs
Clock input and clock output connectors are available. The CLK IN connector accepts either 10MHz or
80MHz (or custom frequency) clock frequency. The optional clock output (CLK OUT) comes from the
CLK IN connector or from the internal oscillator – if clock in signal not present.
The four optional output (T5 – T8) connectors are 50Ω impedance with adjustable amplitude, delay
and width.
Ethernet Port
A RJ45 Ethernet connector is available to control the Model 745 with a computer. See Chapter 8 –
Programming for command syntax.
USB Port (Option)
A female USB connector can be available allowing computer communication with the MOD745.
© Berkeley Nucleonics Corp.
8
Model 745 User Manual