BNC 745 - Manual (Page 21)

Model 745 Digital Delay Generator. November 2013
8- P
ROGRAMMING
Ethernet connection/communication
Generality
For connection over a LAN, you have to do the following:
• Connect the instrument to the LAN physically,
• In the graphical user interface, specify the LAN address,
• On the control PC, enter the instrument’s IP address,
• After the connection has been established, the following commands can be used to modify
the settings:
o
Set’s the instrument’s IP address with: IP XXX.XXX.XXX.XXX
o
Query’s the instrument’s IP address with: IP? ⇒ :IP XXX.XXX.XXX.XXX
o
Set’s the instrument’s IP mask with: NM XXX.XXX.XXX.XXX
o
Query’s the instrument’s IP mask with: NM? ⇒ :NM XXX.XXX.XXX.XXX
o
Set’s the instrument’s IP gateway: GW XXX.XXX.XXX.XXX
o
Query’s the instrument’s IP gateway with: GW? ⇒ :GW XXX.XXX.XXX.XXX
Command structure
Each command description is composed at least of some of the following items (all commands are
used in a telnet prompt):
• Full command syntax,
• Form Set / Query,
• Brief description,
• Parameters,
• RST value,
• Specified limits.
• Example.
*IDN?
Syntax: *IDN?
Form: Query
Description: Queries instrument identification. Answer gives instrument model,
serial number and firmware version.
Parameter: -
RST value -
Example: BNC,MODEL 745,53901/F,V1.1
Instrument model: MOD745
Serial number: 53901,
Channel number: F => 4 active channels (FF => 8 active channels)
Software version: 1.1
BURST TRIG
Syntax: BTRIG Source
BTRIG? source
Form: Set & Query
Description: Trigger source for Burst mode: internal, external or local
Parameter: Source: IN1, IN2, EXT, SSL
RST value -
© Berkeley Nucleonics Corp. 20 Model 745 User Manual