Operating example, Default value, Initial setup – BNC 745 User Manual
Page 19: Setting up the instrument (recurrent mode), Perating example
Model 745 Digital Delay Generator.
November 2013
7- O
PERATING EXAMPLE
Default value
These values are the one stored by default:
• IP: 99.0.0.18
• Gateway: 99.0.0.01
• NetMask: 255.0.0.0
• Frequency1: 1000Hz
• Frequency2: 1000Hz
• TX Level: 5V, Width: 200ns.
Initial setup
Turn on the Model 745 with the rear panel power switch.
After 30 seconds, the following information are displayed:
MOD745 Sn xxxxx,4 V1
SELF TEST
Setting up the instrument (Recurrent mode)
The aim is to set a repetitive frequency of 1000Hz to output pulse T1, with an amplitude of 4V and a
width of 1µs. Use keys to configure the settings as following (Internal frequency 1 has been set to
1000Hz previously):
Button operation
Display
Start at menu item #1
Up 2 times and press OK
T1
Trigger = OFF
Up 1 time
T1
Ampl 5.00 V
Press OK
T1
Ampl 5.00 V
Left 2 times
T1
Ampl 5.00 V
Up 1 time
T1
Ampl 4.00 V
Press OK
T1
Ampl 4.00 V
Up 1 time
T1
Width 200 ns
Press OK
T1
Width 200 ns
Left 3 times
T1
Width 200 ns
Up 1 time
T1
Width 1200 ns
Right 1 time
T1
Width 1200 ns
Down 2 times
T1
Width 1000 ns
Press OK
T1
Width 1000 ns
Up 2 times and press OK
T1
Trigger = OFF
Up 1 time
T1
Trigger = IN1
Press OK
T1
Trigger = IN1
© Berkeley Nucleonics Corp.
18
Model 745 User Manual