BNC 745 - Manual (Page 28)

Model 745 Digital Delay Generator. November 2013
Web Page control/communication
The user can open a web page to control the MOD745 device via Internet Explorer, Firefox or
Chrome (last versions supported). To access the web page, the IP address of the device has to be
typed in the navigator address field. Once that is done, the user should access to the following page.
Figure - 10. Configuration page
From that page, the user can configure each output pulse (amplitude, width, trigger, delay, inhibit
and delay reference), trigger settings, internal frequencies, external clock and burst mode.
On the first setting change, the user will be asked for Login and Password (Default Login: BNC,
Default password:bnc).
Status LEDs indicate which outputs are active or not and Fault LEDs warn the user in case of errors.
To refresh led status, the user has to click on one off these LEDs.
The “manual trigger button” is used to trigger a channel sets to SS1, SS2 or LSS (Single shot 1 & 2 and
Local Single Shot)
And at last, the user can access to the password setting page by typing in the address field: “Device
IP/passwd.htm”.
Figure - 11. Password page
© Berkeley Nucleonics Corp. 27 Model 745 User Manual