Fast & Fluid HA-mII mediumII - Manual (Page 7)

3 Safety instructions and warnings 5
Before installing the equipment and setting it in operation, read the instructions for use
carefully. This is safer for you and it prevents needless damage to the machine.
The manufacturer accepts no liability if the instructions below are not followed:
•
If a machine has been damaged (during transport, for example), do not attempt to set it in
operation. When in doubt, first contact either the Service department (see section 6.4) or your
supplier.
•
The equipment should be positioned and connected up in strict accordance with the installation
instructions.
•
All local safety regulations and ordinances should be observed.
•
The machine may be connected to a 230 V/50 Hz or a 110 V / 50-60 Hz earthed wall socket
installed in accordance with the regulations. See machine plate for correct voltage.
•
Users should see to it that the machine is kept in good condition. Defective components should be
replaced.
•
In order to prevent physical injury, the doors should be closed and the panelling fitted during
normal use.
•
Keep the keys of the machine in a special, safe place.
•
All service activities (other than routine adjustments) may only be carried out by qualified
technicians. See to it that the mains lead is always kept unplugged while repairs are being carried
out.
•
The standard equipment is only suitable for dispensing water-based color pastes into tins of basic
paint. The use of other solvents may damage the sealing rings and cause the equipment to leak.
The equipment can, however, be adapted for use with other solvents.
•
Because of the design of the valve, a nozzle drill may never be used. Cleaning is done by running
the cleaning program.