Fast & Fluid HA-mII mediumII - Manual (Page 11)

4 Positioning / Installing the machine 9
Before proceeding any further:
Take the installation manual out of the computer packaging and look up the connection
information. This provides a clear description of all computer cables and plugs and the
correct way to connect them.
4.3.3 Installing the computer system (see figure 5)
1. Position the keyboard (number 2), the monitor (number 3) and the computer (number 4) as
shown in figure 5.
2. Feed the keyboard and monitor cables through the base of the machine stand. Make sure they
are running the right way!
3. Connect the 9-pin connector lying in the computer cavity to the computer.
4. Mount the cover plate (figure 4, number 1) such that all cables run behind it.
5. Bundle any loose pieces of cable with the cable ties supplied.
6. Plug the computer and monitor plugs into the internal socket (see figure 5, number 5) and press
in their on/off switches.
7. Attach the bottom plate of the stand using the steel screws supplied.
8. Mount the panel on the back of the machine and fix it in place using the triangular key.
9. Place the triangular key in the special clamp on the inside of the machine (see figure 5, number
6).
10. Attach the power cord to the back of the machine (see 7.2.2).