Fast & Fluid HA-mII mediumII - Manual (Page 14)

5 Operation 12
5.3 Starting the machine
5.3.1 Preparing the machine for use for the first time
1. Turn the red main switch (see figure 6, number 1) to position
You are advised to leave this switch turned on at all times. This is necessary for the automatic
stirring system. It also reduces wear on the machine and the computer system.
Then turn also the green switch (see figure 6, number 12) to position . Now the computer is
turned on. Switch the computer off at the end of the day.
2.
HA-s/m/l
Open the door of the machine and remove the brush tray. Fill the brush tray with water or a
diluted detergent (under no circumstances use a solvent!) up to the level mark. Replace the tray
in the correct position and close the door.
HA-MII
Open the cover. Allow the brushtray to drop by pulling the brushtray handle forwards. Fill the
brushtray with water or a diluted detergent (under no circumstances use a solvent!).
3.
Use the software * to set the stirring interval.
4.
Adjust the thermostat if installed (see the instructions for use supplied with the thermostat).
5.
Fill the canisters with paste up to the indicated maximum level * by opening the flap (figure 6,
number 9) and removing the lid of the canister. The canister can now be filled to the top of the
upper stirrer. Make sure that the piston rod remains at the same height.
6.
Ask your paste supplier for the stirring data for the pastes. It may be necessary to stir the pastes.
Stirring can be started with the aid of the software
* .
ATTENTION: Do not leave the flap (figure 6, number 9) or front door open. The stirring system
does only work by closed doors.
7.
HA-MII
The computerplate can be fixed to the frame using two small bolts. The driptray can be hung
from the turntable frame.
Now you can start the morning program * .
5.3.2 Preparing the machine at the start of the day
1. Open the door of the machine and remove the brush tray. Fill the brush tray with water or a
diluted detergent (under no circumstances use a solvent!) up to the level mark. Replace the tray
in the correct position and close the door.
2.
If necessary, top up the canisters to the maximum level. When you do this it may be necessary
to stir the pastes (ask your paste supplier).
3.
Start the morning program * .
The machine is now ready for the day.
*
see Software manual