ARB 3938020 - Manual (Page 12)

02/12/04 Page 12 of 12 3782865
ASSEMBLY SEQUENCE FOR WINCH BUMPER.
28. 1. Trim off excess plastic as shown.
2. With the trim between the brace and the wing
mark, via the hole in the wing, mark with a
felt tip pen or a scriber.
3. Remove the trim and drill using 6.5mm or ¼”
drill bit.
4. Reposition on the vehicle and fasten using
dome head s/steel bolts and flange nuts.
29.
If fitting fog lights, wire the fog lights as described in the fog light fitting instructions
The fog lights can be adjusted to desired angles by the adjustment bolts located at the back of the
light insert. When adjustment is finalised be sure to retighten the fog light bolts.
30. (If fitting with winch)
Connect the winch control box cables to the winch motor. Refer to the Warn handbook for additional
information. Connect the long winch + & - cables to the vehicle after the bar is installed.
Refer to the Warn winch manual for vehicle wiring instructions.
Ensure that these cables are installed well clear of sharp, hot or moving objects. Secure the winch
cables to the vehicle and winch bumper with the supplied cable ties.