ARB 3452030 - Manual (Page 13)

Last Rev Date: 10-Feb-2007 Page 13 of 15 Fitting instructions# 3783246
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE BAR ON VEHICLE
If fitting optional accessory fog lamps kit
9381FCK follow fitting instructions supplied
with kit. If fitting OE fog lights follow steps 43 –
48.
43. Fit M6 cage nuts and grommet to adaptor
bracket as shown.
44. Fit light to adaptor bracket by locating mount
lugs in light body into holes in adaptor bracket
flanges.
45. Screw adjuster into grommet so that light is
approximately parallel to bracket.
46. Fit adapter bracket and fog lamp assembly
into brackets in bull bar wings, as shown.
47. Bolt in place with M6 x 16 bolt and washer
sets into cage nuts.
48. Route OE fog lamp loom and connect to
lamps.
Fitting plastic fog lamp aperture moldings.
49. I f fog lamps are fitted, cut centre panel out of
light aperture moldings using a hack saw
blade.
50. If fog lamps are not fitted leave centre panel
in place.