ARB 3450130 - Manual (Page 17)

Last Rev Date: 19/04/06 Page 17 of 22 Fitting instructions# 3783216
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
58. Once the bar is secured to
vehicle, using holes in lower
section of bar as a template, drill
10mm holes through mounting
assembly and fix using 10mm
hardware.
(This bolt locks the bar to mounting
assembly. )
59. Using 6mm hardware, secure
plastic inner guard to top hole in
bar.
60. To secure lower hole, drill a
6mm hole through inner guard
aligning with hole in bar.
61. Next is to fit wing panels, firstly
fit M6 caged nuts to outer edges
of panel.
PHOTO IS OF LHS OF VEHICLE
ARROW INDICATES
TEMPLATE DRILLING HOLE.
Warning: Drilling operations can result in flying
metal debris, safety glasses should be worn.