Fluid Management VR-1 Mixer - Manual (Page 7)


Fluid Management Customer Service 1.800.462.2466 6 | V-Series
Important Safety Information
Warnings
• This machine draws
6.0 Amps at 120 ± 10% VAC
3.6 Amps at 220 ± 10% VAC
• DO NOT modify the
provided plug
• Improper use of grounding
plug can result in risk of
electric shock.
Cautions
• Check with a qualified
electrician or service
person if grounding
instructions are not
completely understood or
if in doubt as to whether
product is properly
grounded.
• DO NOT use an adapter or
extension cord with this
product.
• This unit must be plugged
into a dedicated electrical
line.
• To reduce the risk of
electric shock or injury, use
indoors only.
Grounding
This product must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electrical shock by providing an escape for the electric current.
This product is equipped with a cord that has a grounding wire and an appropriate
grounding plug. The plug must be inserted into an outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
Danger
Improper installation of the grounding plug can result in a risk of electric shock. If
repair or replacement of the cord or plug is necessary, DO NOT connect the
grounding wire to either flat blade terminal. The insulation wire with green or green
and yellow stripes on the outer surface is the grounding wire. Check with a qualified
electrician if the grounding instructions are not completely understood or if in doubt
about whether the product is properly grounded. DO NOT modify the plug provided. If
it will not fit into the outlet, have the proper outlet installed by a qualified electrician.
Note: This product is for use on a dedicated nominal 120 Volt
(US only) or nominal 220 Volt circuit where applicable and has a
grounding plug.
Safety and Regulatory Compliance Information
See the affixed labeling on the machine. ETL Listed, conforms to UL STD 1450.
Certified to CAN/CSA STD C22.2 NO. 68.
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.