Fluid Management VR-1 Mixer - Manual (Page 10)


Fluid Management Customer Service 1.800.462.2466 V-Series | 9
Getting Started
Installation
Unpacking and Set up
Follow the steps on the next two pages to set up your V-Series Mixer
Important: Before you plug the V-Series Mixer into a power
outlet, carefully read all of the following installation instructions
and the safety information. It is recommended that at least one
other person assist in taking the machine off the pallet.
1
Make sure these items are available before installing.
V-Series Mixer
Surge protector (recommended, not included)
2
Tools needed for installation:
9/16“ socket wrench and extension
Scissors or diagonal cutters
Straight screw driver
3
Unpack the machine while still on the shipping skid.
a. Remove the interior packaging materials
b. While unpacking, inspect the machine for any damage that may have
occurred during shipping.
If any damage is found, notify the carrier immediately. Arrange for
inspection in order to claim recovery. Claims for damage must be
made by the consignee (YOU). The carrier assumes full responsibility
upon acceptance of the shipment and will not entertain any claims by
the consignor.
Verify the contents against the packing slip. Note if any items are missing
or damaged. Call Fluid Management Customer Service at 1-800-462-2466 if
any items are missing.
4
Remove from skid (see unpacking instructions attached to machine).
a. Open upper cabinet by removing the back screw that secures the top
cabinet to the lower cabinet. Do not discard this screw. (See Figure 1.)
b. Carefully flip the top cabinet forward.
c. Remove shipping bolts located through the holes in the inner base. Using
9/16” socket wrench and extension, unbolt the two bolts that secure the
machine to the skid.
d. Using at least two people, remove mixer from skid and lower to floor.
Warnings
Verify that your mixer is
firmly positioned on the
surface it will sit on.
This machine is not
explosion proof and must
not be used in a flammable
atmosphere or with
flammable materials.
Protect the cords and any
surge protectors from
liquids. Liquids can cause
gradual corrosion of the
power cord which can
result in overheating
To reduce the risk of
electric shock or injury, use
indoors only.
Cautions
DO NOT operate the mixer
until it is in a permanent
location.
ALWAYS route power cords
so they will not be walked
on, tripped over, or pinched
by objects
Avoid using extension
cords with unit.