Barco MGP D5 - Manual (Page 36)

MENU SYSTEM User Guide
36 MGP D5
service menu
For service personnel only. A special service code is needed to
access internal calibration controls and status information. Not
accessible to the user.
test image
Applies a fixed test image for set-up purposes
CONTROL SUB MENU
FOR ALL
Mode
Selects between RS232, RIMI (internal) and LAN control modes.
The projector can be controlled by only one of the modes at a
time.
RS232 address
For use when daisy-chaining several units. Select auto or fixed
address. Only one address scheme is allowed per daisy-chain.
The auto address is allocated following the relative position in
the daisy-chain. The fixed address is an absolute address. Only
unique fixed addresses are allowed.
RS232 fixed
Select a unique fixed address in the range available.
baudrate
Selects between baudrates 4800, 9600 and 19200. A lower
baudrate may be required in installations with long cable runs.
mode
RS232 Address
RS232 Fixed
baudrate
RS232
fixed auto
1
19200 232
232
232