Philips Blu-ray Surround Base HTB3525B 2.1 CH Integrated subwoofer Bluetooth® and NFC HDMI ARC Blu-ray Disc playback - Manual (Page 28)

26 EN
Step 1: Download the latest software
1
Connect a USB flash drive to your
computer.
2
In your web browser, go to www.philips.
com/support.
3
At the Philips Support website, find your
product and locate the Software and
drivers.
» The software update is available as a
zip file.
4
Save the zip file in the root directory of
your USB flash drive.
5
Use the archive utility to extract the
software update file in the root directory.
» The files are extracted under the
UPG_ALL folder of your USB flash
drive.
6
Disconnect the USB flash drive from your
computer.
Step 2: Update the software
Caution
•
Do not switch off the Blu-ray Surround Base or
remove the USB flash drive during the update.
1
Connect the USB flash drive containing the
downloaded file to your Blu-ray Surround
Base .
• Make sure that the disc compartment
is closed and no disc inside.
2
Press .
3
Select [Setup], and then press OK.
4
Select [Advanced] > [Software update]
> [USB].
5
Follow the onscreen instructions to
confirm the update.
» Update process takes about 5 minutes
to complete.
Update software through the
Internet
1
Connect your Blu-ray Surround Base to a
home network with a high-speed Internet
access. (see 'Connect and set up' on page
9)
2
Press .
3
Select [Setup], and then press OK.
4
Select [Advanced] > [Software update] >
[Network].
» If an upgrade media is detected, you
are prompted to start or cancel the
update.
» Downloading of the upgrading file may
take long, depending on your home
network condition.
5
Follow the onscreen instructions to
confirm the update.
» Update process takes about 5 minutes
to complete.
» Once complete, the Blu-ray Surround
Base automatically switches off and
restarts. If it does not, disconnect the
power cord for a few seconds and
then reconnect it.