How to connect your recorder, Ac power supply, Press power on/off – Philips CDR700BK User Manual
Page 15
15
English
Digital optical connection
Instead of the digital coaxial connection you can make use of
the optical input.. Optical connections are less sensitive to
external disturbances.This connection is required for direct
recording from an external digital optical source (e.g. a CD
player, DVD, DAT).
1
Remove the dust caps from the digital optical connections
of both source and CD recorder. Keep the caps in a safe
place.
2
Connect an optical fibre-optic cord
between the OPTICAL IN jack of
the CD recorder and the
OPTICAL OUT jack of the source.
Make sure you insert both plugs
fully, until a click is heard.
➜
Recording can now be done via the digital optical input
(
OPTICAL
).
Digital coaxial connections via a digital receiver
If you have a receiver with digital coaxial in- and outputs, these
connections allow you to make digital recordings from various
sources, connected to the receiver.
1
Connect a digital coaxial cord between the DIGITAL IN-
and OUT jacks on the CD recorder and e.g. the (digital)
AUX in- and output jacks on the digital receiver.
➜
Any digital device, connected to the digital input jacks of
the digital receiver (e.g. CD and DVD) can now be used
as recording source.
Note:Your CD recorder is equipped with a digital coaxial
output (common output for CD recorder & CD player deck).
This output can be used for digital playback.
AC Power supply
1
Check whether the AC power voltage as shown on the
type plate corresponds to your local power voltage. If it
does not, consult your dealer or service organisation.
2
Make sure all connections have been made before
switching on the AC power supply.
3
Plug the power cord supplied into the AC POWER ~
connector and the CD recorder, then into the wall jack.
4
Press POWER ON/OFF.
➜
The CD recorder will switch on. This may take a few
seconds.
Notes:
If the CD recorder is in Standby mode (red LED on), press
any button to activate the recorder.
When the CD recorder is in the “OFF” position, it is still
consuming some power. If you wish to disconnect your CD
recorder completely from the power, withdraw the plug from
the AC Outlet.
CD RECORDER
1
DIGITAL
RECEIVER
1
DIGITAL
IN
OUT
OPTICAL
IN
ANALOG
IN
L
R
L
R
OUT
ANALOG DIGITAL
OUT
L
R
OUT
CD RECORDER
CDR
CD
CD
CDR
CDR
CDR
CDR
CD
CD RECORDER
CD PLAYER
DIGITAL
IN
OUT
OPTICAL
IN
ANALOG
IN
L
R
L
R
OUT
ANALOG DIGITAL
OUT
L
R
OUT
2
CDR
CD
CD
CDR
CDR
CDR
CDR
CD
How to connect your recorder