Philips TSU600099 - Manual (Page 57)

ProntoProEdit 3.0 - User Manual Configuring a CCF
Philips Page 57 of 76
RF Settings
The ProntoPro can be set to transmit radio frequency (RF) signals, which
allows you to operate your devices inside closets or in an adjacent room. To
receive these RF signals and convert them to infrared signals, you will need a
RF Extender (optional).
In the RF settings you can set Extender IDs and Channels. Both have to be
identical to the ID- and CH-dials on the RF Extender(s). Refer to the RF
Extender User Manual for more details.
Note
The RF settings can also be set on the ProntoPro. Refer to the ProntoPro User
Manual for more details.
Defining an Extender ID
1 Open the Device Properties or Macro Group Properties.
2 Select the RF tab.
3 Select an Extender ID.
Make sure that this ID matches with the ID on the RF Extender.
4 Click OK to accept the properties.
-or-
Click Cancel to return without changing the properties.
Defining the RF Channel
1 Open the ProntoPro System Properties.
2 Select the RF tab.
3 Select a RF Channel.
Make sure the RF Channel matches with the CH on the RF Extender.
4 Click OK to accept the properties.
-or-
Click Cancel to return without changing the properties.