BenQ PB6200 - Manual (Page 81)

81
8.0 GENERAL RULES
8.1 The inspection must be carried out by trained inspectors who have good
knowledge about the product.
8.2 The inspection must be based upon the documents concerning the completely
assembled and packed product.
8.3 When more defects appear with the same unit only the most serious defect
have to be taken into account.
8.4 Defects found in accessory packed with the product such as Cable,
Connector, Manual, CD and the like, and being inspected as
a part of the complete product, must be included in the evaluation.
8.5 The evaluation must be within the limits of the product specification and, for
not specified characteristics, refer to the sample machine or the judgment of
BENQ QA Engineer. But any kind of proposals or judgments must be
reasonable and acceptable by both sides.
8.6 Faults must be able to be repeatedly demonstrated.
9.0 TEST CONDITIONS
Unless other prescription, the test conditions are as followings:
Nominal voltage : refer to operation manual
Environmental illumination variable from 400 to 700 lux
Temperature :
Operating : 0~ 35
Storage : -10~ 60
Humidity:
Operating : 10 ~ 90 % RH
Storage : 10 ~ 90 % RH
Altitude:
Operating : 0 ~ 6000 ft above sea
level,