Belkin F5D6051 - Manual (Page 34)

33 32 33 32
Troubleshooting
Installation CD-ROM does not start Setup Utility
If the CD-ROM does not start the Setup Utility automatically, it could
be that the computer is running other applications that are interfering
with the CD drive.
If the Setup Utility screen does not appear within 15-20 seconds,
open up your CD-ROM drive by double-clicking on the “My
Computer” icon. Next, double-click on the CD-ROM drive that the
Installation CD has been placed in to start the installation.
Power LED does not come ON; Adapter is not working
If the LED indicators are not ON, the problem may be that the Adapter
is not connected or installed properly.
Verify that the Adapter is plugged firmly into the USB slot of your
computer. Check to see that the drivers for the Card have been
installed. Right click on the “My Computer” icon on your desktop.
Choose “Properties” and navigate to the “Device Manager” and see
if your USB device is listed without any errors. If an error is indicated
contact Belkin Technical Support.
Link LED is blinking slowly; Cannot connect to a wireless
network or the Internet
If your Adapter appears to be functioning properly, but you cannot
connect to a network or you have a red wireless icon at the bottom
of your screen, the problem may be that there is a mismatch between
the network name (SSID) settings in your wireless network properties.
Check the SSID settings to see if they match. The SSID is
case-sensitive and the spelling on each computer must be exactly the
same in order for the Adapter to connect to the Wireless Router or
Access Point
Note: To check the SSID settings or look for an available network,
double-click the Signal Indicator icon to bring up the “Wireless
Networks” screen. Click “Add” if you do not see the network you are
trying to connect to and type in the SSID. For more information about