beautypg.com

Getting started, Step 2: setting the clock, Using the remote control to operate the system – Philips MX5500D-99 User Manual

Page 22: Caution, English, Open the battery compartment, Close the cover, Press standby on to switch on the dvd system

background image

20

English

Step 1:

Inserting batteries into
the remote control

1

3

2

1

Open the battery compartment.

2

Insert two batteries type R06 or AA, following
the indications (+-) inside the compartment.

3

Close the cover.

Using the remote control to operate
the system

1

Aim the remote control directly
at the remote sensor (iR) on the
front panel.

2

Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TV/AV, TUNER.)

3

Then select the desired function
(for example ÉÅ,

S, T.)

CAUTION!

– Remove batteries if they are
exhausted or if the remote is not to be
used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.

Step 2:

Setting the clock

The clock can be set in either 12-hour or
24-hour mode ("12:00 AM" or "00:00" for
example.)

CLOCK•TIMER

CLOCK•TIMER

SEARCH

PROG

CLOCK•TIMER

2

3

5

4

6

SELECT CLOCK OR TIMER

CLOCK

01:38 PM

13:38

13:38

1

Press STANDBY ON to switch on the DVD
system.

2

Press and hold CLOCK•TIMER until
"SELECT CLOCK OR TIMER" appears.

3

Press T (if necessary) to change the display
to "CLOCK," then press CLOCK•TIMER again
to confirm.

4

Press S / T to set the minutes and hours.
To increase the speed, hold down

S or T.

The changes in minutes will roll over to the

hours.

5

Press PROG to change between 12-hour and
24-hour clock mode.

6

Press CLOCK•TIMER again to store the
setting.

The clock will start working.

To view the clock time in any active
mode

Press CLOCK•TIMER.

The clock will display for a few seconds.

Notes:
– If the DVD system is disconnected from the
power supply, it will erase the clock setting.
– If you do not press any buttons within 90
seconds, the system will exit clock setting mode.

Getting Started

STANDBY- ON

iR SENSOR

DISC 1

DISC 2

DISC 3

DISC 4

DISC 5

DISC 1

DISC 2

DISC 3

OPEN•CLOSE

1

2

3

4

5

6

7

8

9

0

REPEAT

REPEAT

DISC SKIP

DISC MENU

PROGRAM

SYSTEM MENU

SEATING

ZOOM

PREV

NEXT

SURR.

SOUND

VOL

OK

TV/AV

DISC/

MEDIA

TUNER

AUX/DI

STOP

PLAY/PAUSE

buttons on
front panel

DVD system’s
display panel

This manual is related to the following products: