Brother UNINET 1240 - Manual (Page 11)

UNINET IMAGING INC. • BROTHER 1240/1650 • ASSEMBLING THE OPC CARTRIDGE
11124 Washington Blvd., Culver City, California U.S.A. 90232 Ph: 310 280-9620 • Fx: 310 838-7294 • [email protected]
© 2005 Uninet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. Uninet Imaging does not guarantee or warrant downloaded information.
USA
+1-310-280-9620
+1-310-838-7294 Ph:
Fx:
JAPAN
+81-3-44-55-2789
+1-310-838-7294
EUROPE
+34-93-757-1335
+34-93-741-4166
BRAZIL
+55-11-4822-3033
+55-11-4822-3353
ARGENTINA
+54-11-4571-2388
+54-11-4574-3706
www. u n i n e t imaging.com
1. Replace the transfer roller together with its
saddles and the helical gear.
3. Slide the axle from left to right, insert the
bearing in place and the retaining washer to
secure the axle in place.
2. Replace the OPC drum by mounting the
clutch and spring on the right side and engage
the drive gear on the left. NOTE: Before insert-
ing the axle lift the spring loaded contact wire
located between the drive gear of the OPC and
the side of the cartridge.
4. Insert the drum cleaning assembly and with
a Phillips screwdriver and tighten the screws
to secure it to the cartridge. The screw on the
left will pressure the contact between the
assembly and the drum axle.