Baracoda Barcode Reader - Manual (Page 9)

DualRunners – Communication Protocol v1.3 - 9 -
Data Capture
for Workforce
in Motion
Code ID 0x50-0x51
Description Lock/Unlock Data capture module (ie : Scan engine, RFIDdecoder board)
Payload 1 byte :
{0 = Unlock, 1 = Lock}
Response 1 byte : {Bit 0 : Success}
Code ID 0x52-0x53
Description Disable Barcode Programming Functionality
Payload 1 byte :
{1 = Disable barcode programming functionality,
0 = Enable}
Response 1 byte : {Bit 0 : Success}
Code ID 0x56-0x57
Description Get/Set In charge behavior
Payload Get : None
Set : 1 byte :
{shutdown timeout (0 = leave current timeouts (default), 255 = infinity)}
Response Get : 1 byte :
{shutdown timeout (0 = leave current timeouts (default), 255 = infinity)}
Set : 1 byte :
{Bit 0 : Success}
Remarks When scanner in charge, the shutdown timers can be modified
Code ID 0x5A-0x5B
Description Get/Set master mode
Payload Get : None
Set : 1-2 byte(s) :
{1 : enable, 0 : disable}
[OPTIONAL]{1 : disconnect the scanner if connected}
Response Get : 1 byte :
{1 : enabled
0 : disabled}
Set : 1 byte :
{Bit 0 : Success}
Code ID 0x5E-0x5F
Description Bluetooth Commands
Payload {Code ID} “Parameters”
Response If the device responds: {Code ID} “Response”
Else: {0}
Bluetooth specific commands from the Platform2 Bluetooth communication protocol are to be
framed within the payload of this message.