Philips Kaffeevollautomat User Manual
Page 24
setting water hardness
1
Remove the Total Hardness Test strip (attached to page 2) from its
wrap. Dip the strip fully into the tap water you use to brew coffee.
Keep the strip in the water for a few seconds. Then remove the strip,
shake off excess water and wait approx. 30 seconds (until it changes
colour and one or more squares turn red).
2
Press the MENU button.
, The button lights up.
3
Press the ^ button until the message ‘SET WATER HARDNESS?’
appears on the display.
4
Press the OK button.
5
Press the ^ button until the number on the display coincides with
the number of red squares on the test strip.
For example, if 3 squares on the test strip have turned red, you have to set
water hardness 3.
6
Press the OK button to confirm the set water hardness.
, The coffee maker is now programmed to display the ‘PLEASE
DESCALE!’ message based on the actual hardness of the water you
use.
setting language
1
Press the MENU button.
, The button lights up.
2
Press the ^ button until the message ‘SET LANGUAGE?’ appears on
the display.
3
Press the OK button.
4
Press the ^ or % button until the desired language appears on the
display.
5
Press the OK button.
, The appliance automatically exits the MENU mode.
resetting to default settings
If you have changed the preset settings, you can reset the appliance to the
default settings as follows:
Note: The appliance resets all menu parameters except the language and the
clock.
1
Press the MENU button.
, The button lights up.
EnglisH
24
4222.002.6507.7.indd 24
31-08-09 17:45