Burley Nomad - Manual (Page 10)

10
Burley Nomad Owner’s Instruction and Safety Manual
Installing the Safety Flag
Insert the fl ag into the webbing strip on the outside of the
left panel.
Folding Your Burley Nomad
Folding your Burley No mad is ba si cal ly the re verse of
set ting it up. Fa mil iar ize your self with set ting up the trail er
as out lined in this sec tion above.
To knock down your trail er:
1. Remove the safety fl ag.
2. Remove the tongue by pulling out the hairpin cotter
and lock pin and reversing the process previously described.
3. Unscrew the roll bar knobs. Stow the roll bar and the cover in the bottom of the
Burley Nomad along with the tongue. Screw the Roll Bar Knobs back into the
Roll Bar for storage.
4. Release the four side-panel hold-downs. Remove the side-panel assemblies and
lay them between the wheels on top of the main frame.
5. Remove wheels.
IMPORTANT: Read and study sec tions “V. Hitching the Burley Nomad
to Your Bicycle,” “VII. Safety Guide lines,” and “VIII. Safety Check lists”
before using your Burley Nomad.
V. Hitching Your Burley Nomad to the
Bicycle
The trailer hitch was de signed to quickly and safely at tach to virtually all types of
bicycles. It is inserted in front of the left rear drop out of your bicycle.
1. Loos en the knob on the eyebolt until the two arms are spread ful ly apart.
2. Slip the lower hitch arm un der the chain stay (A) and the upper arm above the
seat stay (B). (See il lus tra tion next page.)
3. Wedge the hitch cone all the way back into the angle formed by the stays at the
wheel. Tighten the knob until the arms are fi rmly clamped against the stays.
4. Wrap the safety strap around the in side of the chain stay, over the hitch body,
and back to the D-ring at the end of the tongue.