6— thermostats and accessories, Accessory usage guideline – Bryant QUANTUM PLUS 650A User Manual
Page 6
—6—
THERMOSTATS AND ACCESSORIES
* Do not use in zoning heat pump applications.
† This plate is designed to cover surrounding wall area located behind thermostat.
‡ Thermostat conversion kit is a 24-vac accessory that can turn a 4-wire thermostat application into a 5-wire application. This kit can also be used
to replace a broken thermostat wire, or add an extra wire when needed.
** Outdoor air temperature sensor is an accessory for all Bryant electronic thermostats, except the non-programmable air conditioner version and
builder’s thermostats. It allows the temperature at a remote location (outdoors) to be displayed on the thermostat.
The outdoor air temperature sensor
must be
used with the dual fuel thermostat.
The outdoor air temperature sensor is included with the Thermidistat Control and dual fuel thermostat.
ACCESSORY USAGE GUIDELINE
* For tubing line sets between 50 and 175 ft and/or 20 ft elevation difference between indoor and outdoor units, refer to the Application Guideline
and Service Manual for Residential Split-System Air Conditioners and Heat Pumps using Puron Refrigerant.
† Required for all applications.
Thermostat—Auto Changeover, Non-Programmable, °F/°C, 2-Stage Heat, 1-Stage Cool
TSTATBBNHP01-B
Thermostat—Auto Changeover, 7-Day Programmable, °F/°C, 2-Stage Heat, 1-Stage Cool
TSTATBBPHP01-B
Thermostat—Auto Changeover, 7-Day Programmable, °F/°C, Dual Fuel, Includes Outdoor
Sensor (TSTATXXSEN01)
TSTATBBPDF01-B*
Thermidistat™ Control—Non-Programmable/Programmable Thermostat with Humidity
Control (For use in Dual Fuel, AC, HP, and 2S applications. Includes Outdoor Air
Temperature Sensor.)
TSTATBBPRH01-B*
Builder’s Thermostat—Manual Changeover, Non-Programmable, °F/°C, 2-Stage Heat,
1-Stage Cool, Heat Pump
TSTATBBBHP01*
Outdoor Air Temperature Sensor
TSTATXXSEN01
Backplate for Non-Programmable Thermostat
TSTATXXNBP01†
Backplate for Programmable Thermostat and Thermidistat™ Control
TSTATXXPBP01†
Backplate for Builder’s Thermostat
TSTATXXBBP01†
Thermostat Conversion Kit (4 to 5 Wire)—10 Pack
TSTATXXCNV10‡
ACCESSORY
REQUIRED FOR LOW-AMBIENT
APPLICATIONS
(Below 55°F)
REQUIRED FOR LONG-LINE
APPLICATIONS*
(Over 50 Ft)
Crankcase Heater
Yes
Yes
Evaporator Freeze Thermostat
Yes
No
Compressor Start Assist—Capacitor and Relay
Yes
Yes
Puron Low-Ambient Pressure Switch
Yes
No
Wind Baffle
See Low-Ambient
Pressure Switch Instructions
No
Support Feet
Recommended
No
Puron Hard Shutoff TXV
Yes†
Yes†
Puron Liquid-Line Solenoid Valve for Heating
No
See Long-Line
Application Guideline