BOXLIGHT CD-450m - Manual (Page 25)

17
Turning Off the Projector
If you want to turn off the projector for a short period of time,
press the
standby button on the keypad or remote. This blanks the
screen for fifteen minutes, but keeps the projector running. (You
can change the amount of time the projector stays in standby
mode; see “Standby Time” on page 30 for details.) After 15 min-
utes, the lamp goes out (the projector keeps running). To exit
standby mode, press the
standby button again. (It may take sev-
eral seconds for the projection lamp to reach full power and
project the image again.)
To completely power off the projector, press the “O” side of the
power switch on the side of the projector. If you want to turn the
projector back on immediately, you must allow about a minute
for the lamp to cool. The lamp won’t light if it’s too hot.
CAUTION: When you discon-
nect the projector after you have
switched it off, always remove the
power cord from the electrical out-
let first, then remove it from the
projector.