Philips Saeco Nina Machine espresso manuelle - Manual (Page 17)

• 17 •
English
Key to machine components (Page 2)
1 Control panel
2 ON/OFF button
3 Water Tank
4 Hot water/steam knob
5 Drip tray & grill
6 Coff ee brew unit
7 Cappuccinatore
8 Power
cord
9 Ground coff ee measuring scoop
10 Pressurized portafi lter
11 Ground coff ee fi lter
(single piece for 1 or 2 coff ee(s))
12 Pannarello
13
Pod fi lter adapter
14 Coff ee pod fi lter
15 Single coff ee brew button
16 Double coff ee brew button
17 Hot water button
18 Steam button
4 INSTALLATION
For your and other people safety, follow the "Safety
Regulations" in section 3 carefully.
4.1 Packaging
The original packaging has been designed to protect the
machine during transport. We recommend keeping the
packaging for future transport.
4.2 Installation Instructions
Before installing the machine, read the following safety
instructions carefully.
• Put the machine in a safe place.
• Make sure children cannot play with the machine.
• Do not place the machine on hot surfaces or near open
fl ames.
The coff ee machine is now ready to be connected to the power
supply.
Note: it is recommended to wash the
components before using them for the fi rst
time and/or after they have not been used for a certain
period of time.
4.3 Machine Connection
Electric power can be dangerous! It is therefore
essential to follow the safety regulations carefully.
Do not use faulty cords! Faulty cords and plugs must be
immediately replaced by authorized service centres.
Appliance voltage has been pre-set by the manufacturer. Make
sure that the power voltage matches the indications on the
identifi cation plate on the bottom of the appliance.
• Make sure that the ON/OFF button (2) is not pressed before
connecting the machine to the power supply.
• Fit the plug into a wall socket with suitable power voltage.
4.4 Water Tank
• (Fig.1) - Remove the water tank (3).
• (Fig.2) - Rinse the water tank and fi ll it with fresh drinking
water taking care not to overfi ll it.
• (Fig.1) - Reinsert the water tank into its seat and make sure
that it has been placed correctly.
Use only fresh, non-sparkling drinking water
to fi ll the tank. Hot water, as well as any other
liquid, may damage the tank. Do not turn on the
machine with empty water tank: make sure there is
enough water in the tank.
4.5 Circuit Priming
At the beginning, after dispensing steam or when the water
tank is empty, the machine’s water circuit must be primed. In
this case, the 4 buttons of the control panel will blink at the
same time.
• (Fig.3) - Press the ON/OFF button (2). The 4 buttons will
fl ash.
• (Fig.4) - Place a container under the cappuccinatore.
• (Fig.5) - Open the "hot water/steam" knob (4) by turning it
anticlockwise.
• (Fig.6) - Press the hot water button (17).
• Wait for water dispensing to stop.
•
Close the "hot water/steam" knob (4) by turning it clockwise.
Remove the container.
When the fi rst priming ends, the warming up
starts. Before brewing coff ee, water and steam,
please wait for lights 15 and 16 to be permanently on.
Note: if priming is not completed, the 4 buttons
will keep on fl ashing. The machine cannot be
used.