Bay Technical Associates 529H - Manual (Page 36)

By responding to the Enter Request: message at the end of the main
configuration menu (see
Section 6.1 ) with " 5 " (Set Control Character),
you may change the control character.
WARNING: BayTech advises you to log your new control character. If
it is forgotten, you will not be able to control the unit or access the
configuration mode.
CONTROL
CHARACTER____________ DATE______ BY___
CONTROL
CHARACTER____________ DATE______ BY___
The multiport will respond with:
Current Control Character is...............14H
Enter Control Character in Hex.............:
You may now enter the new control character that you want in HEX
(00 to 7F Hex). For example, if you enter "
15 " ( Control-U ), the
multiport will respond with:
Current Control Character is...............15H
Save Changes Permanently? (Y/N):
If you answer " Y " (yes), the new control character will be saved in
non-volatile memory, and the multiport will respond only to that
character. The multiport will respond with:
Are You Sure? (Y/N):
This message gives you a second chance to consider this change and
reminds you to log your new control character. If you answer either
question with "
N " (no), the new control character will be stored in RAM
and lost upon next power-up. The multiport will return to the main
configuration menu (see
Section 6.1 ).