Bay Technical Associates 529H - Manual (Page 16)

This section discusses user-programmable operations (see Section
5.1 ), operating in the different modes (see Section 5.2 ), binary mode
(see Section 5.3 ), break condition (see Section 5.4 ), and data flow
control (see Section 5.5 ).
You may select from six modes of operation. You may also select the
serial port configuration and handshaking for each individual port, the
data block length, the message terminating character, and the control
character. These changes are made by accessing the menu-driven
configuration mode.
The multiport will translate for devices using different serial
configurations. You may set the baud rate, word size, stop bits, parity
and XON/XOFF handshaking for each individual port.
Factory default configuration on all ports is 9600 baud rate, 8
word size, 1 stop bit, no parity, XON/XOFF disabled.