BT 5500 - Manual (Page 7)

If you experience any problems, please call the Helpline on 0800 145 6789* or email [email protected]
7
WARNING
Do not place your BT Synergy in the bathroom or
other humid areas.
Handset range
The BT Synergy has a range of up to 300 metres
outdoors when there is a clear line of sight
between the base and handset. Any obstruction
between the base and handset will reduce the
range significantly. With the base indoors and
handset either indoors or outdoors, the range will
normally be up to 50 metres. Thick stone walls
can severely affect the range.
Signal strength
The icon on your handset indicates when you
are in range. When out of range of the base the
icon will flash and the out-of-range tone will
sound every minute. This tone is repeated until
you move back into range.
IMPORTANT
The base station must be plugged into the mains
power at all times. Do not connect the telephone
line cord into the wall socket until the handset is
fully charged. Only use the power and telephone
cables supplied with the product.
Location
You need to place your BT Synergy base within 2 metres of the mains power
socket and telephone socket so that the cables will reach.
Make sure it is at least 1 metre away from other electrical appliances to avoid
interference. Your BT Synergy works by sending radio signals between the
handset and base. The strength of the signal depends on where you site the
base. Putting it as high as possible ensures the best signal.
Setting up
Connect the base
1. Plug the mains power cable into the socket marked on the underside of
the base and plug the other end into the mains power wall socket and switch
the power on.
The telephone cable is pre-installed in the base but do not connect the other
end to the telephone wall socket yet.
Getting started
Telephone line cord
(pre-installed)