Brother 1810 - Manual (Page 82)

78
CAN’T
HERE! • This message appears if
the cursor is at the end of
the text when you hold
down and press
.
• Move the cursor below a
number before holding
down and press-
ing .
CHANGE
ADAPTOR • This message appears if a
high-voltage adaptor is
being used.
• Remove the high-voltage
adaptor and connect the
adaptor designed exclu-
sively for this machine.
CUTTER
ERROR! • This message appears if
the tape cutter lever is
pressed down while a
label is being printed.
• Release the tape cutter
lever.
INVAL.
CHRS! • This message appears if
the cursor is not below a
number when you hold
down and press
.
• Move the cursor below a
number before holding
down and press
.
LENGTH
LIMIT! • This message appears if the
text is longer than 1 meter
when you try to print.
• Shorten the text to less
than 1 meter before trying
to print.
• This message appears if
the Length function is
used to set a label length
that is less than 1.6” (4.0
cm) or more than 11.8”
(30.0 cm).
• Set the label length
between 1.6” (4.0 cm)
and 11.8” (30.0 cm).
• This message appears if
the Tab Length function is
used to set a tab length
that is more than 11.8”
(30.0 cm).
• Set the tab length so that
it is less than 11.8” (30.0
cm).
Error Message Cause Remedy
Number
Number
Number
Number