Brother 1810 - Manual (Page 36)

32
TAB FUNCTION
This function allows you to separate sections of a line of text by adding tabs. This enables
you to create perfectly aligned columns without having to type in several spaces. All tabs
have the same length and are measured from either the beginning of the line or the previ-
ous tab if there is more than one. The tab length can be set between 0.0” and 11.8” (0.0
and 30.0 cm).
☞
The text can contain no more than 50 tabs. If 50 tabs have already been added to
the text when is pressed, the error message “TAB LIMIT!” appears.
To set the tab length:
1 Hold down and press once. The current tab length is displayed.
2 Press or until the desired length is displayed or use the number keys to
type in the length.
☞
To change the units (inches or centimeters) used to display the tab lengths,
press until the desired units are displayed.
3 Press .
To add a tab:
● Hold down and press once. The tab mark ( ) appears in the text to
indicate the position of the tab.
☞
If the text in front of a tab extends past the point where the next section of
text should start, the text will instead start at the following tab position.
For example, if the tab length is set to 2” and the following text is typed in:
Tab
Tab Length
Home
End
Tab
2: J K L M N O P Q R S T U
1: A B C D E F G H I