Belkin F5D7231-4P - Manual (Page 139)

136
Troubleshooting Troubleshooting
137
se
ct
io
n
2
1
3
4
5
6
7
8
9
10
11
12
13
5. Select “TKIP” or “AES” under “Date Encryption”. This setting will
have to be identical to the Wireless Router or Access Point that
you set up.
6. Type in your encryption key in the “Network Key” box.
Important:
Enter your Pre-Shared key. This can be from 8 to 63
characters and can be letters, numbers, or symbols. This same
key must be used on all of the clients that you set up.
7.
Click “OK” to apply settings.
Problem:
I can’t print from one of the computers on my network. What do I do?
Solution:
For the PC to be able to print to the networked printer (printer on the print
server), the printer’s software and drivers must be installed on the PC.
Every manufacturer ships its printer with a driver and, usually, printing
software. Be sure that you have installed the printer drivers and software
on each PC from which you plan to print. In some cases, while installing the
drivers and software for your printer, you may be required to connect the
PC directly to the printer in order to complete the installation. This varies
according to manufacturer.
Problem:
I keep getting the error message, “Cannot find the Router” when running the
Print Server Wizard. What do I do?
Solution:
If the Print Server Wizard is not able to find the Print Server in the Router,
this means the computer does not have a valid connection to the Router. The
most common causes of this issue are:
1. Wired computers (those not connected wirelessly):
Check the
cable between the computer and the Router. Make sure the light
on the front of the Router that corresponds with the port on the
back of the Router is lit. (If the computer is plugged into port 4,
make sure the light for port 4 is lit).