Neff B46E54N3GB - Manual (Page 28)

28
Removing the intermediate panel
Note: Before removing, make a note of the position in which
the intermediate panel is fitted, so that you do not refit it the
wrong way round later.
1. Remove the seal. Pull the seal outwards and remove it
upwards (fig. B).
2. Release and remove the retainer (fig. C).
3. Lift the intermediate panel slightly and take it out (fig D).
Cleaning
Clean the door panels with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
Note: During installation, make sure that the lettering "top right"
is upside down at the bottom left.
1. Insert the intermediate panel towards the back as far as it will
go (fig. A).
2. Hook in the seal on both sides (fig. B).
3. Insert the retainer (fig C).
4. Press down on the retainer until it locks into position (fig. D).
Fitting the door panel
1. Insert the door panel at an angle towards the rear into the
retainers (fig. E).
2. Press down on the side of the door panel until it locks into
place (fig. F).
3. Refit the appliance door.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1. Pull out and detach the hook-in rack at the front (Fig. A).
2. Clean the hook-in rack with washing-up liquid and a sponge
or brush.
3. After cleaning, refit the hook-in rack in the reverse order
(Fig. B).
%
' &
% $
' &
) (
$ %