Care and cleaning, Tips for saving energy, Warning – Sharp SJ-FP760VST User Manual
Page 13: Important, Defrosting, When the compartment light is blown, When transporting, Switching off your refrigerator
13
The amount of power consumption of this model is
measured according to the international standard of the
refrigerator performance under the following conditions .
All accessories in the freezer
•
compartment are taken out as
indicated on the figure.
Space dimensions.
•
WARNING
Unplug the refrigerator first to prevent electric shock.
■
Do not splash water directly on the outer cabinet or the
■
interior . This may lead to rusting and deterioration of the
electrical insulation .
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips .
Wipe any food oils adhered to plastic components.
•
Some household chemicals may cause damage, so use only
•
diluted washing-up liquid (soapy water).
If undiluted detergent is used or soapy water is not wiped off
•
thoroughly, cracking of plastic parts can result.
1
Remove the accessories e.g. shelves from the cabinet and
door. Wash them in warm soapy dishwashing water; rinse
in clean water and dry.
2
Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off soapy
water.
3
Wipe the exterior with a soft cloth each time it is soiled.
4
Clean the Magnetic door seal with a toothbrush and warm
soapy dishwashing water.
5
Wipe the control panel with the dry cloth.
NOTE
To prevent damage to your refrigerator, do not use heavy duty
•
cleansers or solvents (lacquer, paint, polishing powder, benzine,
boiled water, etc.).
If the power supply is disconnected, please wait for at least 5
•
minutes before re-connecting power.
The glass shelves weigh approximately 3 kg each. Hold firmly
•
when removing from the cabinet or carrying.
Do not drop objects inside the refrigerator or strike the inner wall.
•
This may cause the inner surface to crack.
Defrosting
Defrosting is fully automatic due to a unique energy saving
system.
When the compartment light is blown
Contact the service agent approved by SHARP to request a
replacement compartment light. The compartment light is not to
be removed other than by qualified service personnel.
When transporting
Wipe up water in the evaporating pan. Before wiping up the
•
water, wait more than 1 hour after pulling out the plug because
refrigeration cycle equipment is extremely hot.
(The evaporating pan is located on the rear of the product.)
The casters allow the refrigerator to
•
move back and forth.
Carry the refrigerator by holding the handles located on the
•
rear and bottom.
Switching off your refrigerator
If you switch your refrigerator off when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power socket
and leave all doors open.
CARE AND CLEANING
Casters
Keep the ventilation space as much as possible around the
■
refrigerator.
Keep your refrigerator out of direct sunlight, and do not
■
place next to heat generating appliance.
Open your refrigerator door as briefly as possible.
■
Hot foods should be cooled before storing.
■
Place the food evenly on the shelves to allow the cooling air
■
to circulate efficiently.
300mm
90mm
300mm
60mm
Evaporating pan
Tips for saving energy
(B325)W.indb 13
2012/05/30 13:28:25