Nokia 3660 - Manual (Page 21)

Copyright © 2003 Nokia. All rights reserved.
Your phone
21
pause of approximately two seconds before, or between DTMF characters.), and w (if
you use this character, the remaining sequence is not sent until you press
Send again
during the call). Press to produce #.
2 To send the tone, press OK .
Tip! You can also store a sequence of DTMF tones for a contact card. When you
make a call to the contact, you can retrieve the sequence. Add DTMF tones to the
phone number or
DTMF fields in a contact card.
Settings for call diverting
When this network service is activated, you can direct your incoming calls to another
number, for example, to your voice mailbox number. For details, contact your service
provider.
Go to Menu →
Tools → Call divert .
• Select one of the divert options, for example, select If busy to divert voice calls when
your number is busy or when you reject incoming calls.
• Select Options → Activate to set the divert setting on, Cancel to set the divert setting
off, or Check status to check whether the divert is activated or not.
• To cancel all active diverts, select Options → Cancel all diverts .
For information about the divert indicators, see ‘Indicators related to actions’ , p. 9 .
Note: You cannot have barring of incoming calls and call diverting active at the
same time. See
‘Call barring (network service)’ , p. 43 .
Log - Call register and general log
Go to Menu → Log . In the log you can monitor phone calls, text messages, packet data connections, and fax
and data calls registered by the phone. You can filter the log to view just one type of
event and create new contact cards based on the log information.