Enhancements, Configuration, Enhancements configuration – Nokia 6085 User Manual
Page 89: Ee “configuration,” p, Activate the hearing aid mode
S e t t i n g s
56
■ Enhancements
This menu is shown only if the phone is or has been connected to a compatible
mobile enhancement, other than the charger.
Select
Menu
>
Settings
>
Enhancements
. You can select an enhancement menu
if the corresponding enhancement is or has been connected to the phone.
Depending on the enhancement, select from one of the following options:
Default profile
— to select the profile that you want to be automatically activated
when you connect to the selected enhancement.
Automatic answer
— to set the phone to answer an incoming call automatically
after five seconds. If
Incoming call alert
is set to
Beep once
or
Off
, automatic
answer is off.
Lights
— to set the lights permanently
On
. Select
Automatic
to set the lights on
for 15 seconds after a keypress.
Ignition detector
>
On
— to automatically switch off the phone approximately
20 seconds after you switch off the car ignition, when the phone is connected
to the full car kit.
TTY/TDD
>
Use TTY
>
Yes
— to use text phone settings instead of headset settings.
Activate the hearing aid mode
Select
Hearing aid
>
T-coil hearing aid mode
>
On
to optimise the sound quality
when using a t-coil hearing aid. The
icon is shown when the
T-coil hearing
aid mode
is active.
If you make an emergency call to 911 while the phone is in the hearing aid mode,
the phone will use as much power as it needs (up to the maximum available) to
connect the call. More information on accessibility can be found at
.
■ Configuration
You can configure your phone with settings that are required for certain services
to function correctly. The services are multimedia messaging, instant messaging,
synchronization, e-mail application, streaming, and browser. Your service provider
may also send you these settings as a configuration message.
To save the configuration settings received as a configuration message, see
“Configuration settings service,” p. 10.
Select
Menu
>
Settings
>
Configuration
and one of the following options: