Nokia 6190 - Manual (Page 9)

7
Attaching the battery when using optional
analog module
1) Place the analog
module on the back of
the phone
2) Slide the module
toward the top of the
phone until it clicks into
place
3) Place the battery on
top of the analog
module
4) Slide the battery toward the top of the phone until
it clicks into place
Charging your new battery
Your phone is powered by a rechargeable Li-Ion or
NiMH battery. Note that a new NiMH battery’s full per-
formance is achieved only after two or three complete
charge and discharge cycles.
Note: Use only batteries approved by the phone manufacturer
and recharge your battery only with the chargers approved by
the manufacturer.
Also, see “Important Battery Information” on page 100 for
important battery usage information and “Talk and Standby
Times” on page 92 for approximate battery operation times.
With your phone on or off, simply connect the lead
from the charger to the bottom of your phone or to a
charging stand. Then connect the charger to a
standard 120V AC outlet.
Note: If you have purchased an optional analog module, be
sure to remove it and replace the battery before placing the
phone in a charging stand. Although the phone will fit in the
stand with the analog module attached, charging will not take
place.
When the battery is charging, the battery-strength
indicator on the right side of the display will scroll.
When you charge the battery for the first time, the
battery-strength indicator will not scroll the entire time;
this is normal.