Nokia 6190 - Manual (Page 36)

34
If the caller can be identified, the caller's phone num-
ber (or name, if stored in the phone book) and the text
FDOOLQJ appears while the phone is ringing. If the name
is too long to be displayed, its end is replaced with an
ellipsis (...). If the caller cannot be identified, only
&DOO is
displayed.
If you subscribe to the Call Forwarding network
service and the incoming call has been forwarded from
another phone number, the
! sign is shown after
FDOOLQJ.
Calling card
If you wish to use a calling card for
long distance calls, you must first
store your calling card information
into your phone. Your phone can
store two calling cards.
Programming a calling card
1) Press
0HQX 4 1 5 (6HWWLQJV - &DOO#VHWWLQJV - &DOOLQJ#
FDUG)
(For details on how to work the Menu, see
page 13)
2) Press W or V to reach desired calling card, then
press
2SWLRQV
3) Press W or V to reach
(GLW, then press 2.
4) Enter security code and press
2.
5) At
'LDOLQJ#VHTXHQFH, press 6HOHFW. Press
W or V to
choose the dialing sequence your card uses (see
chart on page 35), then press
6HOHFW.
Note: The order of the following steps may vary, depending on
which dialing sequence your card uses.
6) Enter access number (usually the 1-800 number
listed on the back of the calling card), press
2.
7) Enter card number and/or PIN, press
2.. Your
phone will display
6DYH#FKDQJHV". Press 2..