Nokia 3200 - Manual (Page 55)

44 Copyright © 2004 Nokia
• Press and hold the 1 key.
• Select Listen if there is a notification message in the display.
• From the menus, select Messages > Voice messages > Listen to
voice messages.
Once you connect and the prerecorded greeting begins, follow the automated
instructions to listen to your voice messages.
Automate voice mail
You can insert special characters called dialing codes into phone numbers such as
voice mail and then save the number to a 1-touch dialing location. Dialing codes
instruct the receiving system to pause, wait, bypass, or accept the numbers that
follow them in the dialing string.
Note: Each voice mail service can vary. The examples and steps that follow
are for clarification. Check with your service provider if you have specific
questions about your voice mail service.
WRITE DOWN SOME INFORMATION
You will need this information in “Set up voice mail with dialing codes” on page 45.
Be sure to record all of the information correctly.
1 Write down your voice mailbox number.
2 Call and check your voice mail as you normally would.
3 Write down your interaction with the recorded prompts step-by-step. Keep in
mind that each voice mail service may vary. However, it should look something
like this:
Dial 2145551212, pause 5 seconds, press 1, pause 2 seconds, press 1234, press # key.
INSERT DIALING CODES
Press the * key repeatedly to cycle through dialing codes. Once the desired code
appears in the display, pause briefly and the code is inserted into the dialing string.
For example, press the * key four times to display w (wait character). Pause briefly
and the wait character is inserted into the dialing string. Available dialing codes are
as follows:
* Bypasses a set of instructions.
+ Precedes an international telephone number.
p Pauses for 2.5 seconds before sending any numbers that follow.
w Wait. Your phone waits for you to press the Talk key before it sends any
numbers or codes that follow.