Toshiba Magnia 3100 - Manual (Page 66)

58 HW Diagnostics
SCSI HDD TEST
SCSI HDD TEST (HDD)
Status Error name Meaning
01 CHECK CONDITION OR BAD COMAND Bad command error
03 DRIVE SELECTION FAILED ID selection error
04 TARGET DRIVE BUSY The target drive is busy
05 SCSI BUS TIME OUT Time out error of SCSI bus
09 DMA BOUNDARY ERROR DMA BOUNDARY occurred
0D COMMAND TERMINATED A command terminated
0E QUEUE FULL Command queue is full
80 NO SENSE The sense data is invalid
81 RECOVERED ERROR The execution of the command has
correctly finished because of
recovery treatment.
82 NOT READY The condition does not satisfy for the
command execution
83 MEDIUM ERROR An error occurred because of the failure
of a medium
84 HARDWARE ERROR A hard error that is impossible
to recover occurred during
command execution
85 ILLEGAL REQUEST CBD is illegal
86 UNIT ATTENTION The function of hard disk drive has been
changed
87 DATA PROTECT Data protection error
89 VENDOR UNIQUE A unique error of disk maker
8A COPY ABORTED Stop of COPY command
8B ABORTED COMMAND The execution of a command
is correctly stopped
8C EQUAL The comparing result of the
search data command is
satisfied
8E MISCOMPARE Comparing command error
E0 STATUS ERROR Status error
F0 OTHER ERROR Other errors
FE NO DRIVE ERROR The target drive has not been found
FF DATA COMPARE ERROR Data comparing error
*Definition of SCSI HDD TEST Details Information (DETAILS = XXXXXXXXXXXXXXX)
NOTE: The [01. Sequential address read] tests all areas of the hard disk drive. If the capacities of
installed hard disk drives are large enough, the test may take a few hours.
If you do not know where the hard disk drives are connected (host ID, SCSI ID and channel number of
the SCSI controller), you can find them from [01. INQUIRY] of [09. SCSI TEST].