Toshiba Magnia Z500 - Manual (Page 26)

To enable an Agent to output SNMP traps or display Agent information on the Management
Console, the SNMP properties must be properly set up in advance.
·
Settings for installation of the Agent or Management Proxy function:
Select the check box for “Send authentication trap”. Select “public” for “Accepted
community names” and select “READ CREATE”, “READ WRITE”, for Authority. Finally,
select the option button for “Accept SNMP packets from any host”.
If you want to select “Accept SNMP packets from these hosts”, write the IP address of the
PC in which the Management Proxy function is installed.
16