Toshiba Magnia 3200 - Manual (Page 8)

Magnia Rack Conversion Kit
2. Extend the other slide rail. Secure the server to the slide with three
M5 ×8 screws on each side in the order shown in the illustration
below. Screw No. 1 is secured through a hole in the base rail.
Figure 1-54 Securing three screws on each side
3. Slide the server into the “42” rack so that a fourth M5 ×8 screw hole
on the slide rail is aligned with the hole in the base rail used to secure
screw No. 1. Secure a fourth screw to prevent the server from
accidentally sliding out of the “42” rack.
8 TOSHIBA Europe GmbH
Magnia Rack Conversion Kit – 3030_3100_s00056-EN.doc – Gosen – Printed on 14/11/2001 as PRINTFILENAME