Toshiba Magnia 3200 - Manual (Page 10)

Magnia Rack Conversion Kit
3. When extending the rail, the stopper comes from the joint and the rail
could not be inserted. When inserting the rail push the stopper in.
Figure 1-57 Attaching the rail lock mechanism
4. Seat the lock plate and secure it with two M3 ×6 screws.
CAUTION : Pull the server out carefully to test if the lock is properly
secured.
5. The cable arm has three sections as shown below. Secure section
“a” to the server with two M4 ×8 screws and section “b” to the “42”
rack with two M6 ×16 screws. Finally, align screw holes on section
“c” with holes on sections “a” and “b” and secure four M4 ×8 screws.
Figure 1-58 Installing the cable arm
10 TOSHIBA Europe GmbH
Magnia Rack Conversion Kit – 3030_3100_s00056-EN.doc – Gosen – Printed on 14/11/2001 as PRINTFILENAME