Toshiba Magnia 3200 - Manual (Page 11)

Magnia Rack Conversion Kit
Version
7
Last Saved on 14/11/2001 11:48
6. Secure the signal cable and AC power cable to the cable arm with
bands as shown below. Make sure the cables extend down on
opposite sides. If the signal cable is on the right, the AC power cable
should be on the left.
Figure 1-59 Securing signal and AC power cables
7. Check the cable positions.
8. Roll up the excess cable and secure it with plastic clamps to the 19”
rail so that it will not be damaged by installation of another server or
other components.
Figure 1-60 Checking the cable positions
9. Check the slide mechanism.
NOTE : Check that the cable/chassis/arms do not touch other devices.
Be sure to check from the front and back sides.
TOSHIBA Europe GmbH 11
Magnia Rack Conversion Kit – 3030_3100_s00056-EN.doc – Gosen – Printed on 14/11/2001 as PRINTFILENAME