Belkin OmniView Secure Kvm Switch F1DN102U - Manual (Page 17)

12
Installation
Step 3 Connecting Computers to the Switch (required)
3.1 Make sure all computers and the Switch are powered off.
3.2 Using the Belkin All-In-One USB KVM Cable Kit (F3X1962bXX), connect the
male VGA connector to the monitor port on your computer. Then connect
the female VGA connector to the CPU monitor port on the Switch labeled
“VGA 01”. (Refer to diagram below.)
3.3 Using the Cable Kit, connect the USB Type A connector to an available
USB port on your computer. Then connect the USB Type B connector to
the USB port on the Switch labeled “USB 01”. (Refer to diagram below.)
3.4 Repeat steps 2 and 3 for each additional USB computer you wish
to connect.
Note: The Cable Kit must be connected directly to a free USB port on your
computer, with no USB hubs or other devices in between.