Belkin OmniView Secure Kvm Switch F1DN102U - Manual (Page 16)

11
1
2
3
4
5
6
7
se
ct
io
n
Installation
Step 2 Connecting the Console to the Switch (required)
Warning: Before attempting to connect anything to the Switch or your
computers, please ensure that all computer equipment and devices are
powered off. Plugging and unplugging cables while computers are powered
on may cause irreversible damage to the computers and/or the Switch.
Belkin International, Inc., is not responsible for damage caused by your
failure to do so.
Before you connect your console to the Switch, make sure that your USB
keyboard and mouse work properly with all your computers (the Human Interface
Device (HID) USB drivers are installed on all computers).
2.1 Connect your monitor VGA cable to the VGA port on the back of the
Switch in the “User Console” section. (Refer to diagram below.)
2.2 Connect your keyboard and mouse USB cables to the USB keyboard and
mouse ports on the back of the Switch in the “User Console” section.
(Refer to diagram below.)